UltraClear Epoxy Coverage Charts
(for Deep Pour please see below)
For most epoxy projects, UltraClear Epoxy is applied in two stages: the Seal Coat stage and the Flood Coat stage.
Seal Coat: The seal coat is a small batch of epoxy that is brushed on in a thin layer to seal any pores in the surface and prevent air bubbles from forming in the following flood coat. Our epoxy is used for both the seal coat and the flood coat. It is the same product that is applied to the surface with a paint brush.
Flood Coat: After waiting 4-6 hours from when the seal coat was applied, a flood coat is simply poured onto the surface, at which point it self-levels to 1/8" thick.
Side and Edges: If you'll be pouring over the sides and edges of a table, countertop, or bar top, we recommend that you purchase extra epoxy resin to account for spillage over the sides, as you may lose about 30% of the resin while coating those particular areas.
*Covering embedded objects will require additional epoxy. Make sure you have accounted for this.
**The calculations below are (either) (or) for the seal coat and flood coat. For example: 1 gallon will cover either 16 sq.ft. for a flood coat or 48 sq.ft. for a seal coat—NOT BOTH. These calculations are not intended to give more than a rough estimate. Precise epoxy needs will vary according to many factors, including application type and surface material. For specific advice regarding your project, contact our customer service department
Have questions? Want advice? Contact us!
If you have any questions or concerns about resin surface coverage, or if you'd like epoxy project planning advice, please reach out to us.
You can contact us via phone or email here. During business hours, you can also chat with a resin specialist directly on our website by clicking the Help button located at the bottom right of your screen.
